Once you press a key, the first keypad will be enrolled into the first slot automatically. Once the system is loaded the keypad should display: Press any key to enroll. Power up the system by plugging in the AC power transformer and then attaching the backup battery.
This will help ensure that you have hardwired zones available for expansion without needing to reprogram anything. We recommend, in most cases, using the first zones for hardwired devices and leaving any zones that have hardwired terminals available reserved for hardwired devices. It is also extremely helpful to have all your zones written out and in front of you during programming so that you can easily reference it. For wireless sensors, it is useful to have them laid out nearby for enrollment purposes. We recommend getting all your hardwired components in place and wired to the main board before programming.
Zone alarm pro serial number code#
If at anytime you get lost, STOP, and hit #, and then start over.Įntering Programming: *8 - Installer Code If you get a long beep, the system did not like what you entered. A quick triple beep means the system accepted you entry and is now ready for the next entry. If using an LED or ICON keypad, you will not see a display or any numbers during your programming. These keypads will allow you to see what section are in and what you enter and this quick start guide will assume you have one. NOTE: We heavily recommend programming using a LCD keypad. Doing so may cause problems in the function of your alarm system. WE DO NOT RECOMMEND BEING IN ANY PROGRAMMING SECTION THAT IS NOT IN THIS GUIDE UNLESS YOU FULLY UNDERSTAND THE FUNCTION OF THAT SECTION.
0 kommentar(er)
